How to Mark a Rugby Pitch

The short answer

To mark a rugby pitch, peg the four corners of the field of play and check both diagonals are equal, then run string lines for the touchlines and goal lines. Mark the halfway line, the solid 22m lines, the broken 10m lines either side of halfway, the broken 5m and 15m lines parallel to the touchlines, and the dead-ball and touch-in-goal lines of each in-goal area.

Up to 100mField of play length
Up to 70mWidth
6–22mIn-goal depth
22mLine from goal line

Whether you're marking out a club ground for the first time or refreshing lines for the new season, this guide takes you from measuring out to the final line. For GAA and football pitches, see how to mark a GAA pitch and how to mark a football pitch, or compare all sports in the pitch dimensions guide.

Rugby pitch dimensions

Field of play: 94–100m (100m shown) In-goal6–22m In-goal6–22m 22m22m 10m10m Halfway line 5m line15m line Width: 68–70m (70m shown)
Marking Measurement
Field of play length 94–100m (max 100m)
Field of play width 68–70m (max 70m)
In-goal area depth 6–22m behind each goal line
22m lines 22m from each goal line (solid)
10m lines 10m either side of halfway (broken)
5m and 15m lines Parallel to touchlines (broken)
Perimeter area At least 5m where practicable

Rugby union, World Rugby Law 1. Diagram drawn to scale at 100m × 70m with 10m in-goal areas.

What you need

How to mark a rugby pitch: step by step

  1. Prepare your paint

    Mix concentrate before filling the machine. A rugby pitch takes about 10% more paint than a football pitch: roughly 2.8L of Clubline White, 2.2L of Lumen White or 1.7L of Extreme White, mixed with water at the same ratio as for football. Ready-to-use paints (Direct, Edge) go straight in with no mixing.

  2. Decide your dimensions

    Measure the space you have. The field of play (touchline to touchline, goal line to goal line) is 94–100m long and 68–70m wide, plus an in-goal area of 6–22m behind each goal line. Use the largest layout the ground allows. The 22m and 10m lines are always measured from the goal line and halfway line, so a shorter pitch just shortens the gap between them.

  3. Set out the corner pegs

    Peg the four corners of the field of play, where the touchlines meet the goal lines. Measure both diagonals: if they're identical, the pitch is square.

  4. Mark the touchlines and goal lines

    Run a string line between each pair of corner pegs. The goal lines (try lines) and touchlines are solid lines. Mark these four boundary lines first.

  5. Mark the halfway line

    Find the midpoint of both touchlines and run a string line across the full width. This is a solid line.

  6. Mark the 22m lines

    Measure 22m in from each goal line along both touchlines and run a string line across the pitch, parallel to the goal line. These are solid lines.

  7. Mark the 10m lines

    Measure 10m either side of the halfway line and run a string line across the width, parallel to the halfway line. These are broken (dashed) lines.

  8. Mark the 5m and 15m lines

    Measure 5m and 15m in from each touchline and run string lines the full length of the field of play, parallel to the touchlines. These are also broken lines.

  9. Mark the in-goal areas

    Measure back from each goal line to set the dead-ball lines, parallel to the goal lines. Extend each touchline into the in-goal area to mark the touch-in-goal lines. The dead-ball and touch-in-goal lines are solid. Keep a clear perimeter of at least 5m around the playing area where practicable.

  10. Apply the paint

    Follow the string lines at a steady speed and height for an even line. For broken lines, switch the sprayer off between dashes and measure the dashes against your string line. Nozzles for concentrates (Clubline, Lumen, Extreme): Yellow F110-020 for initial marking and Green F110-015 for over-marking. For Direct or Edge, use a stainless steel nozzle (No. 6 initial, No. 4 over-mark). See the nozzle guide.

  11. Remove the lines and inspect

    Lift the string lines and pegs, walk the pitch and touch up any gaps. Rinse the machine and nozzles with water straight away (see the cleaning guide).

Tips from the field

  • Mow and clear the cuttings before marking. Paint sticks to short, clean grass and isn't lifted by loose clippings.
  • No goals to work from? Use the 3-4-5 method: 3m along one line, 4m along the other; when the diagonal is exactly 5m, the corner is 90°.
  • Always check the diagonals before painting. A square pitch is the foundation of accurate lines.
  • Mark in dry conditions for better adhesion and longer-lasting lines.
  • Using a robotic marker such as Turf Tank? Use Edge in a recyclable bag-in-box, or Direct.

Best paint for rugby pitches

Best line marker for rugby pitches

All machines come with a 3-year warranty as standard. Compare paints and machines, or see if your club qualifies for a CSFF grant. Free delivery to all 32 counties.

Rugby pitch marking FAQ

What size is a rugby pitch?

The field of play is up to 100m long and up to 70m wide (minimum 94m by 68m), with an in-goal area of 6–22m behind each goal line. The full playing area can be up to 144m long. Use the pitch dimensions guide to compare with GAA and football.

Which rugby lines are solid and which are broken?

Solid lines: touchlines, goal lines, 22m lines, halfway line, dead-ball lines and touch-in-goal lines. Broken lines: the 10m lines (either side of halfway), and the 5m and 15m lines running parallel to the touchlines.

How much paint do I need for a rugby pitch?

About 10% more than a football pitch. As a guide, 10L of Clubline marks about 3.5 rugby pitches. See how much paint to mark a pitch or use the paint calculator.

How often should I re-mark a rugby pitch?

Before every match. On training pitches, re-mark when the lines start to fade. If lines fade faster than you'd expect, see why pitch lines fade.

What paint should I use?

A water-based pitch marking paint made for natural grass. Never use lime or household emulsion: here's why.

Are underage rugby pitches a different size?

Yes. Age-grade rugby uses smaller playing areas, so check your union's age-grade guidance before you set out the pegs. The marking method is the same.